FOR CREATING CANDLE
(1) Turn on the Melting Pot and slide thermostat to the “UTEE” setting.

(2) Remove top off of tin. Position a wick in the center of the bottom half of the tin and place pieces of candle wax around the wick. Before placing tin into Melting Pot, level the Melting Pot by placing the Melting Pot lid under the back portion of the Melting pot to “even it out.”

(3) Place tin in the center of the Melting Pot. Carefully add pieces of wax to the tin as needed until it is to desired height in the tin. Turn off Melting Pot and let the wax fully set and the tin completely cool before removing the tin from the Melting Pot.

(4) Dip the Perfect Pearls brush into Forever Green Perfect Pearls and dust the candle wax to make it shimmer!

FOR CREATING DECORATIVE TIN
(5) Scoop a small amount of Perfect Gold Perfect Pearls onto the Non-Stick Craft Sheet with the spoon end of the Kool Toolz Tweezers. Add a small amount of water and stir with the Perfect Pearls brush to make a thin paste consistency. Repeat process with Forever Green Perfect Pearls. Apply both colors to the entire tin with a brush and let dry. Note: Because of the resins and binders in Perfect Pearls, the “paint” will set and dry on the tin surface!

(6) Turn on the Melting Pot again and slide thermostat to the “UTEE” setting. Pour Clear UTEE into the Melting Pot to the fill line. Add about 2 tbsp. of Black UTEE. Cover with Melting Pot lid and let melt. Tip: do not stir UTEE while it is melting because it may result in bubbles in your finished project.

(7) Once melted, gently stir the Clear and Black UTEE so it mixes together using the Kool Toolz Spatula.

(8) Sprinkle very small amounts of Forever Green and Perfect Gold Perfect Pearls Pigment Powders into the melted UTEE in the Melting Pot. Stir slowly with the spatula swirling the Perfect Pearls on the surface of the UTEE.

(9) Place the lid of the tin on the Non-Stick Craft Sheet and slowly pour enough melted UTEE onto the lid to cover the top and rest inside the lip of the tin. Let cool. Note: if you accidentally pour over the lip of the tin, wait for the UTEE to cool, pry off and try again.

(10) Ink up Alphabet stamp with Perfect Medium Pad. Pour enough UTEE on the Non-Stick Craft Sheet to make a medallion for the lid. Press Alphabet Stamp into the UTEE, let sit until cool and remove from rubber. Adhere to top of tin with Super Glue Gel™ and when set, rub Perfect Pearls on the medallion with your finger.

(11) Ink up Alphabet stamp again with Perfect Medium pad and place face up on Non-Stick Craft Sheet. Pour UTEE onto stamp in a 3-4 inch line about _” wide. Allow UTEE to set (use Kool Tool Tweezers to press into the UTEE to test), but while still slightly warm, pull the UTEE from the stamp and gently bend it around the base of the tin. Adhere with Super Glue Gel™. Repeat process for other side of tin. Note: There is no waste with UTEE! If a poured piece doesn’t turn out the way you wanted, just wait until the UTEE cools and put back into the Melting pot to re melt!